How To Clean Halogen Bulb After Touching

1. Hi all - I noticed when buying a new halogen bulb for my bathroom yesterday it mentioned not to touch with bare skin.

   A few questions:

   - is it only halogen bulbs you shouldn't touch with bare skin?
   - how would you indentify these in a house?
   - is it dangerous to use a bulb which may have been touched by bare hands?

   Thanks in advance.

   Andy

2. Sponsored Links

4. If you clean them properly before turning them on it's a non issue. It's the oil from our hands that isn't good for them - something to do with the oil/glass and temperatures. Touching them while off doesn't do any harm as long as you remember to clean them properly before turning them on.

   I do a lot of computer stuff so have a tin of isopropyl alcohol which I use but other things should work okay as long as they remove all oil and leave nothing nasty in its place.

   • Thanks x 1

5. Thanks for your response. How would I know which bulbs can't be touched and which are ok to?

6. • Thanks x 1

7. Here is a selection of halogen lamps, note that the capsule is small and very close to the filament, also the "glass" (quartz) is quite thick...
   These are the type you shouldn't touch with bare hands

   Traditional lamps like this,

   
   ...and lamps where there is a halogen capsule but it's inside another layer of glass like this,
   are OK to handle.

   Dammit, too late again!

   • Thanks x 1

8. Thanks again for a really helpful reply.

   I was thinking more for bulbs which i may have previously touched around the house unknowingly when changing fittings etc .

   Will the bulbs specify whether they are Halogen or not on the actual bulb itself?

9. Thanks Robin that's a really helpful response and answers my Q above. Very much appreciated.

10. If you've already touched various bulbs around the house and they're in use, don't worry too much. There's nothing you can do about it now and the worst that'll happen is they won't last very long and might blow more violently than usual. Fittings that use bare halogen lamps are usually required to have some kind of safety shield anyway to catch the bits if the lamp does go pop.

    • Thanks x 1
11. Sponsored Links

13. Really do appreciate your input Robin - ive been really worrying about things.

    The halogen bulb in my bathroom was indeed protected by a casing.

    Going forward though to confirn it's only halogen bulbs I need to be careful with? Would a bit of tissue paper be ok to hold the bulb with and if I did touch prior to fitting would glass cleaner suffice to clear off marks with?

    So I feel completely comfortable if I was to take some pics of the various bulbs in use in my house tomorrow could you kindly advise whether any are those which shouldn't be touched? To clear my mind i would most likely replace these if there are any.

14. I would have said always needs some type of safety shield. I know it breached health and safety regulations to use quartz flood lights without glass closer than 5 foot without glass due to UV rays given off. The touching quartz tends to make that point attract the tungsten causing a hot spot and premature failure with the long tubes this was a real problem but seen wagon headlight bulbs encrusted in mud where glass has broken and they did not seem to blow.

    Using paper OK and often packet designed to rip off after fitting. There are very few bulbs used in the home where you can touch the quartz.

    • Thanks x 1

15. If you have bulb's in use already around the house, then don't worry.

    They are either not halogen, or its too late to worry.

    The worse that will happen is that the bulb will go black and fail, and you will have to buy a new one.
    Go disturbing old bulbs and you are more likely to cause them to break, rather than any oil that could be on the glass.

    When installing halogens, use tissue or the foam they come with to install.
    If you do touch a halogen, then something like aftershave maybe worth trying if you don't have any IPA.

    These are halogens. The packaging usually makes it obvious not to touch.

    
    Car headlight bulbs are also halogen

    • Thanks x 1

16. Thanks all.

    Bit confused by the term Quartz and how this links in?

    So it sounds like halogens not enclosed in another glass are the only light to avoid touching?

    I am a worrier as you can probably tell and so your continued support and advice in an area i am very unfamiliar with is most appreciated.

17. The quartz bit is referring to the fact that the glass capsule used for halogen lamps is not normal glass but special high temperature quartz glass. Quartz halogen lamps will almost always have symbols like the two lower ones here...
    ...on the packaging or instruction leaflet, to warn against touching them with bare hands.

    As we've already said, don't worry about ones you have already installed, if you've touched them you've probably shortened their life but nothing you can do about that now.

    • Thanks x 1

18. Thanks all for some great advice - massively appreciate everybody's input.

19. The envelope is not glass, it is quartz, as this gives the high temperature tolerance and strength needed.https://en.wikipedia.org/wiki/Halogen_lamp#Handling_precautions

    IPA will be fine, or meths. Or vodka, or one of those medical wipes which are impregnated with alcohol.

    • Thanks x 1

20. If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

    Select the supplier or trade you require, enter your location to begin your search.

    Please select a service and enter a location to continue...

    Are you a trade or supplier? You can create your listing free at DIYnot Local

Share This Page

How To Clean Halogen Bulb After Touching

Source: https://www.diynot.com/diy/threads/lightin-bulbs-and-touching-with-bare-skin.441559/

Posted by: kinneytryin1978.blogspot.com

Share this post